Settings Button; Adjustable Parameter 1: Min Feed Rate; Adjustable Parameter 1 Controller Will Display Aug; Adjustable Parameter 2: Temperature Offset - Rec Tec Grills RT-2500 Owner's Manual

Test Mode: With grill OFF, press and hold the Settings Button to enter the Adjustable
Parameters Menu. Enter Test Mode from either of the two screens AUG or OFS by
pressing the Power Button. Each additional press of the Power Button will advance
you through the 8 Test Mode screens. The last screen is the bYE screen. While on the
bYE screen, press the Settings Button to return to the adjustable parameters screen
Due to varying qualities of pellet brands, we give you the ability
to adjust your minimum feed rate downward in the event that
your grill is running hot at lower temperatures. However, if you
experience a sudden loss, followed by an immediate increase,
in grill temperature then your grill has experienced a flame out
and automatically relit. This signifies that your minimum feed
rate was adjusted too low and needs to be increased.
Questions? CLICK for support!
then press and hold the Settings Button and your grill's
controller will return to the OFF state.
Adjustable Parameter 1: Min Feed Rate - Min Feed
Rate is the minimum rate that the auger is allowed to feed
fuel to the fire pot, regardless of Set Point. Decreasing the
value will allow the grill to achieve lower temperatures but
will increase the risk of flame-outs. Increasing the value will
prevent losing fire but will limit your ability to maintain low
temperatures on hot, sunny days.

Adjustable Parameter 1 controller will display AUG.

Additionally, the current auger minimum feed rate will be
displayed as a number. Turning the Temperature Control
Knob clockwise will increase and turning counter-clockwise
decrease the value within the range of 30 - 250. (Factory
preset: 65)

Adjustable Parameter 2: Temperature Offset -

Your grill has been precisely calibrated at our facility, but
the Temperature Offset allows you to customize how your
controller will operate. Should you choose to rely on a
secondary temperature probe, you can use the following
process to recalibrate your Smart Grill Technology Controller.
Adjustable Parameter 2 will display OFS.
Additionally, the current temperature offset percentage
value will be displayed. Turning the Temperature Control
Knob clockwise will increase and turning counter-clockwise
decrease the value within the range of -25.0 to 25.0. (Factory
preset: 0)
22
Settings Button: Press and hold the
Settings Button to access the adjustable
parameters menu. Short presses of the
Settings button will scroll through the
adjustable parameters. Pressing and
holding the Settings Button will exit the
adjustable parameters menu.
Back to Table of Contents
©2019, REC TEC Industries, LLC