Fujitsu MB95210H Series Application Note page 11

//===================================================================
//extern unsigned int delay_timer;
__interrupt void DefaultIRQHandler (void);
// Vector definition
// Use following statements to define vectors.
// All resource related vectors are predefined.
// Remaining software interrupts can be added hereas well.
#pragma intvect DefaultIRQHandler 0
#pragma intvect DefaultIRQHandler 1
#pragma intvect DefaultIRQHandler 2
#pragma intvect DefaultIRQHandler 3
#pragma intvect DefaultIRQHandler 5
#pragma intvect DefaultIRQHandler 6
#pragma intvect DefaultIRQHandler 7
#pragma intvect DefaultIRQHandler 8
#pragma intvect DefaultIRQHandler 14
#pragma intvect DefaultIRQHandler 18
#pragma intvect DefaultIRQHandler 19
#pragma intvect DefaultIRQHandler 20
#pragma intvect DefaultIRQHandler 22
#pragma intvect DefaultIRQHandler 23
__interrupt
void DefaultIRQHandler (void)
{
__DI();
While(1)
__wait_nop();
}
Main.c
//=====================================================================
//following code created for DBG pin usage test
#define DEBUGMODE
//set DBG pin as P12 output
void gpio_setting(void)
{
DDR1_P12 = 1;
PDR1_P12 = 0;
AIDRL_P04 = 1;
}
DBG pin operation V1.0
Chapter 5 Sample code
// disable interrupts
// halt system
/* set P12 as output pin */
/* pull P12 to low. */
/* port input enable */
MCU-AN-500009-E-10 – Page 11
//IRQ0: external interrupt ch4
//IRQ1: external interrupt ch5
//IRQ2: external interrupt ch2 | ch6
//IRQ3: external interrupt ch3 | ch7
//IRQ5: 8/16-bit timer ch0 (lower)
//IRQ6: 8/16-bit timer ch0 (upper)
//IRQ7: LIN-UART (reception)
//IRQ8: LIN-UART (transmission)
//IRQ14: 8/16-bit timer ch1 (upper)
//IRQ18: 10-biat A/D-converter
//IRQ19: Timebase timer
//IRQ20: Watch timer / counter
//IRQ22: 8/16-bit timer ch1 (lower) |
// external interrupt ch 12-15
//IRQ23: Flash | Custom ch1