Advertisement
Note: For the first use, it is recommended to delete all program scenes
before you start programming. Remainders of unfinished programs can
produce undesired and unpredictable results.
8.2 Deleting Scenes
To delete one or more scenes in a program, proceed as follows:
1. From start mode, press and hold A for ± 2 seconds to enter programming
mode.
The dot blinks in the PROG display, which indicates the currently selected
program (1-9). The SCENES display shows the number of recorded
scenes (00-50) in the selected program. If SCENES displays 00, it means
that no scenes have been recorded yet for the selected program.
2. To delete the last scene in the program, press DELETE twice.
3. To delete all scenes in the program, press and hold DELETE until SCENES
displays 00.
4. Use UP and DOWN to select another program and repeat if necessary.
5. To quit and return to start mode, press and hold A for ± 2 seconds.
8.3 Programming Scenes
To program scenes, proceed as follows:
1. From start mode, press and hold A for ± 2 seconds to enter programming
mode.
The dot blinks in the PROG display, which indicates the currently selected
program (1-9). The SCENES display shows the number of recorded
scenes (00-50) in the selected program. If SCENES displays 00, it means
that no scenes have been recorded yet for the selected program.
2. Use UP and DOWN to select the desired program (1-9).
3. Press B and use UP and DOWN to select the desired device/page (1-9).
4. Move the faders to set the DMX channels for the selected device/page to
the desired values.
5. Use UP and DOWN to select another device/page, and move the faders
again to the desired position.
Caution: After you change devices/pages, the position of the faders does
not represent the real setting. Move the faders beyond the desired
position and back to make sure that the DMX value is set correctly.
6. Repeat until you have set all devices/pages.
7. Press INSERT twice to save the scene in the current program.
The number of scenes in the SCENES display increases by 1.
8. Repeat steps 3-7 for all the next scenes that you want to program.
9. To quit programming and return to start mode, press and hold A for
± 2 seconds.
V. 01 – 28/06/2013
VDPC054
9
©Velleman nv
Advertisement
