Door Springs Drain Pump Drain Valve Electrical Cord Reel; Tank Seal Assembly - Hobart KitchenAid KD-18 SERIES Service Manual

Fig. 43
Tank Seal Assembly
I. Remove outer door panel.
2. Remove hinge pin retaining clips and hinge
pins.
3. Unhook door springs.
4. Lift off door.
Fig. 44
5. Remove tank seal (2, Fig. 43) by pulling on
end.
6. To reassemble tank seal , insert seal at one end
and pull it through.
DRAINING CONVERTIBLE-PORT ABLE
DISHWASHERS
Drain dish washer hoses before serv1cmg any
component which requires placing dishwasher on
its back or when making conversion to under-the-
counter installation. Remove lower rack, wash arm
and strainer.
I. Tilt dishwasher to rear at 45° angle.
(Diswasher should be braced on box or
similar object).
2. Remove lower front panel.
Fig. 45
3. Place suitable container under hose con-
nections (both fill and drain hoses) at the fill
and drain valves.
4 . Disconnect hoses from fill and drain valves.
5. Drain hoses into container.
Electrical Cord with Reel (KDI-58 & KDS-58
Only) (2, Fig. 44)
To remove power cord with reel:
- 24-
I. Remove two mounting screws
(1,
Fig. 45)
from power cord housing.
2. Remove power cord housing (I, Fig. 46) and
push through slot opening, provided in the
housing.
3. With unit drained, lower rack, wash arm and
strainer removed, place dishwasher on back.
Protect fmish by laying it on a rug or similar
object.
4. Remove lower front panel.
5. Disconnect electrical leads from reel.
6. Remove one mounting screw (1, Fig. 44) and
slide cord reel to the right and lift out.