Semtech TS8000 Flash Series Programming Manual page 8

Programming Sequence
1. Connect the Semtech USB-I2C adapter to the TS8000x target board via the 4 wire cable.
2. On the TS8000x target board, ground the Debug pin.
3. Connect the USB-I2C adapter board to your PC with a USB cable.
4. If separately powered, apply power to the TS8000x target board.
5. Launch the GUI by clicking on the icon:
Device
6. On the tab,
select the TS8000x
version that matches
your device
7. Verify the Status
indicates the selected
Connected
TS8000x is
8. Click on the
Firmware
tab
www.semtech.com
TS8000x Programming Guide 7 of 16
Rev 0.9 Sep 2016 Semtech