Advertisement
Checklist 1: Semtech USB-I2C Adapter & Wireless Power
GUI
Software Installation
1. At www.semtech.com, keyword search for
GUI
to download
Tools and Firmware
2. Under the
setup.exe
3. Extract
setup.exe
4. Run
Hardware Preparation
1. Obtain a Semtech USB to I2C adapter board from a
EVM kits can be found at:
2. Connect I2C serial clock, data, and ground from the adapter board to the target board as shown
below.
Note that Vcc should not be connected if target board is independently powered.
3. To invoke bootloader mode, tie DEBUG to ground on the target board.
4. Powerup the target and plug the adapter board into the USB port on the programming PC.
Programming Sequence
1. Launch the GUI by clicking on the
Device
2. On the
device.
3. Verify the Status indicates the selected TS8000x is
Firmware
4. Click on the
5. Locate the firmware BIN file to be installed via the
Program
6. Click
7. Note the green progress bar and verify the download succeeded.
8. Close the GUI, power down the boards and remove the cables.
TS8000x Programming Guide
Rev 0.9
Sep 2016
SemtechWirelessPowerGUI_setup.zip
tab, download image file
WirelessPowerGUI_setup.msi
and
and follow the prompts to install the Semtech Wireless Power GUI software.
http://semtech.com/wireless-charging.
Semtech Wireless Power GUI
tab, select the TS8000x version that matches your
tab.
to begin the download.
www.semtech.com
TS80000.
Docs & Resources,
Under
to your PC.
160815a_TX_LOW_POWER_TS51223_enc.
from the zip archive.
TSWITX-EVM
icon:
Connected.
...
button.
TS8000X
click
13 of 16
Semtech
Hide quick links:
Advertisement
