Checklist 2: Aardvark Adapter And Text-Mode Script - Semtech TS8000 Flash Series Programming Manual

Checklist 2: Aardvark Adapter and Text-Mode Script

Preparation
1. Obtain an Aardvark I2C/SPI Adapter kit from
2. At www.semtech.com, keyword search for
Programming using text-mode script" to download
Tools and Firmware
3. Under the
4. Extract the files within
\TS80002_Programming\fw_flash_Semtech_v1.0\Aardvark USB Driver.
5. Navigate to
TotalPhaseUSB-v2.12.exe
6. Unzip
TotalPhaseUSB-v2.12.exe
7. Run
Programming Sequence
1. Connect three Aardvark ribbon cable pins to the TS8000x target board:
2. On the TS8000x target board, short the
3. Connect the Aardvark I2C/SPI Adapter to the PC with a USB
cable.
Verify the "Total Phase Aardvark..." driver loads as per the
image to the right:
4. Apply power to the TS8000x target board
TS8000x Flashing\TS80002_Programming\Executable
5. In
specifies 160815a_TX_LOW_POWER_TS51223_enc.BIN as the firmware image which must be
in the same directory).
6. A window similar to the one shown
to the right should open. When the
final line "Please disconnect the
device" is displayed, the installation
is complete.
7. Close the window, power down the Aardvark and the target board, and remove the cables.
TS8000x Programming Guide
Rev 0.9 Sep 2016
TS80000.
tab, download image file
TS80002_Programming.zip
TotalPhaseUSB-v2.12.zip.
from
and follow the prompts to install the Aardvark USB driver.
Debug
www.semtech.com
http://www.totalphase.com/
Docs & Resources,
Under
TS80002_Programming.zip
160815a_TX_LOW_POWER_TS51223_enc.
with subdirectories maintained.
Function
Clock
Ground
Data
GND.
pin to
programming.bat
, click on
"
click TS8000x
to your PC.
Aardvark Target
pin Board
1 SCL
2 GND
3 SDA
. (The batch file
15 of 16
Semtech