IKEA MOJLIG Manual page 17

ENGLISH
The installation must be compatible with the
current local regulations. Complying with
the local regulations, the connection of the
cooktop to the gas pipe network or gas
cylinder must be made by means of a rigid
copper or steel pipe with fittings, or by
means of a continuous surface stainless
steel hose.
If there is a problem with the
pipe, do not repair it yourself.
Contact the local After Sales
Service Provider. Refer to the
Service chapter.
The connection must be installed correctly
and fixed into the hob connection pipe.
Otherwise, gas may leak from the
connection pipe.
Warning! When you finish the
installation, check the sealing
and pipe fixing. To check the
installation, use soapy water. Do
not use the flame.
Conversion to G2.350 gas
• Auxiliary and semi-rapid burner: after
you assembly the injectors (
following figure), screw their cages
(diameter 10 mm,
on, included in the supply (primary air
regulators).
• Rapid burner: after assembly the
injectors ( in following figure), screw
3
their cages (diameter 16 mm,
following figure) on, included in the
supply (primary air regulators).
3 in
1 in following figure)
2 in
4
In both cases use the special cap
tool and a screwdriver to
4
secure the cages.
Be sure to remove the cap tool
before reassembling the burners.
Adjusting flame level
When you install the hob, it is necessary to
check the minimum flame setting:
1. Turn the gas tap to the maximum
position and ignite.
2. Set the gas tap to the minimum flame
position and turn the control knob from
minimum to maximum several times. If
the flame is unstable or extinguished,
follow the procedure further.
3. Re-ignite the burner and set to
minimum.
4. Remove the control knob .
17
1
2
3