Advertisement
TALTERI DIVK-700 INSTALLATION
The air exchange unit is meant for warm inner facilities. Suitable installation spots are, among others, office, dressing or
household facilities and technical or warm storages. In case the temperature of the installation location is lower than room
temperature, the factory settings of the appliance must be changed to obtain faultless functioning. The unit can not be
installed into cold outer premises or garages. Exhaust of condensing water proceeds through a water-sealed joint hose
into a washing basin or "dry" floor well. Check the horizontal position of the unit and free flow of the condensing water.
The unit can be mounted on a wall with corner trims, which should be attached with M8 screws to the rivet nuts on the
sidewalls of the unit. To install the unit on the floor, attach the 150 mm high plinth legs (available as accessories) to the
bottom of the unit with M8 screws. Raising the unit above the floor leaves space for the condensate water hose and the
power cord. The unit can be attached also to the ceiling with threaded bars or with plinth legs, which should be attached
to the rivet nuts on the top of the unit.
The outlet hose of condensing water has readily installed
water-sealed rising joint that can be taken right into the wall
sewerage. Check that the hose is not pressed together.
There must be only one water-sealed joint between the
appliance and sewerage.
ELECTRICAL CONNECTIONS
Electrical connections must be done following the
installation manual and wiring scheme.
ELECTRICAL CONNECTIONS CAN BE DONE ONLY BY
AN
ENTREPRENEUR
INSTALLATION RIGHTS.
Electrical connection box can be opened from the front
side below the unit by removing the screws beneath the
locking covers. The connection box slides out by pulling it
forward up to the end stop guide.
DIVK-700 DE is connected to an electrical socket with a
3x2,5 power cord. If the unit is equipped with a pre-heater,
a 4x2,5 power cord should be used instead of a 3x2,5
power cord.
The cable connecting the unit to a pre-heater is coming
from the unit's electrical box through the bottom entry of the
unit located near its backside
The operating panel is connected to the control board by
modular connector.
The following can be connected as accessories:
-
Carbon dioxide transmitter
-
Humidity transmitter
-
Separate Overload or Extended Period switch
(pulse switch)
-
Separate Boost switch (pulse switch) or setting off
as pre-data (for instance, sauna oven, stove hood)
-
Remote control or out-of-home switches (pre-data)
-
Differential pressure switches for filters
-
Outside pre-heating
The functions can be operated through maintenance -
and setup menus of the operating panel.
WITH
RESPECTIVE
Distripution board
DIVK-700 DE
OVER-
PRES-
SURE/
EXTEN-
DED
TIME
Figure 5: Electrical connections
5
UN-
OC-
CU-
PIED/
RE-
WATER
FIL-
BOOS-
MO-
COO-
BATTERY
TER
TING
TE
LING
Advertisement
