Advertisement
Using the sPDS-480ca On-Board Menu
sPDS-480ca has a navigable LCD screen with three menu levels.
Menu Level
1
2
NET: IP Address ...
MAC Address
Network
Data Rate
Serial Number
Lights
Lights Per Port
View Status
Internal Temp
Temperature
Min / Max Temp
Fan Status
Set IP
10.X.X.X
Address
Scan Lights
Press Select
Low
Medium
Fan Settings
High
Auto*
Turn Lights Off*
Thermal
Configure
Ramp Down Lights
Settings
Stay On
Bright
Medium*
LCD
Dim
Backlight
Auto-Dim
Restore
Press Select
Defaults
All Off
All Red
All Green
All Blue
All White
Rainbow
Test Lights
Test
Single Port
Single Light
Test
Fans on Full
Reset
Press Select
System
About
Press Select
* Default settings.
8
sPDS-480ca
Product Guide
Description
3
Displays device's current IP address
Displays device's MAC address
Displays an estimate of network bandwidth currently
used by the device
Displays the device's serial number
Displays the nodes scanned for each port
Displays an estimate of the device's internal
temperature
Displays minimum and maximum temperature since
device was last turned on
Displays whether fan is on or off, and speed of fan as
percentage of maximum
Modifies the device's IP address
Discovers and counts the nodes connected to each port
Sets fans to run continuously at the selected speed. If
temperature rise is detected, fan speed automatically
switches to High until the temperature reaches a safe
level.
Fan speed automatically adjusts based on the detected
temperature
If device overheats, lights turn off
If device overheats, lights smoothly fade out
If device overheats, lights remain on
Sets the brightness of the device's LCD backlight
Dims the LCD backlight when no buttons have been
pressed for 15 seconds
Restores factory default settings for LCD Backlight, Fan
Settings, and Thermal Settings. Network configuration is
unaffected.
Turns off all nodes
Turns on all channels of a particular color
Cycles through red, green, and blue, showing waves of
different colors across all nodes
Turns on nodes connected to one port. Press Select to
begin test. Press the Down button to begin automatically
cycling through the device's ports. Press the Down
button again to manually cycle through the device's ports.
Turns on a single node. Press Select to begin test. Press
the Down button to begin automatically cycling through
the connected nodes. Press the Down button again to
manually cycle through the connected nodes.
Turns on the device's two fans at full speed
Resets the device. This has the same effect as powering
it down and turning it back on. Your configured settings
are unaffected.
Displays system information, including unit model, serial
number, and firmware revision number
sPDS-480ca 7.5 V
Ethernet
To navigate the on-board menu:
•
Press the Up and Down buttons
() to move up and down in the
current menu's set of options.
•
Press the Select button (
select a menu item or display its
submenu.
•
Press the Cancel button () to
return to the previous menu level.
) to
Advertisement
