Advanced Features; Run A Zone Manually; Run A Program Cycle Manually - Signature Control Systems, Inc. EZ Pro Jr. 8300 Series Installation And Programming Manual

ADVANCED FEATURES - AUTO MODE
The EZ Pro ™ Jr. incorporates two manual/test procedures for checking
the function of the controller or allowing you to bypass the current
program to water immediately. The following section will show you
how to set up the controller to:

• Run a zone manually

• Run a program manually
NOTE: All test procedures are run with the MODE dial in the AUTO
position. This allows the controller to reset to the AUTO
setting after running a manual/test procedure. It also allows
you the ability to walk away from the controller after setting
up a manual/test procedure and not have to come back to
reset the controller to AUTO.
NOTE: All manual/test procedures ignore the sensor connection.
Therefore, you can water utilizing one of the manual/test
procedures even if the sensor has suspended your scheduled
program.
Run a Zone Manually
Turn the large dial to the MANUAL position. The default of zone 01 and
00:10 minutes will be flashing (recall that this means you can change
them). Press SELECT to select the zone number that you want to run.
Press ADJUST to set the run time for the selected zone. The controller
will delay 5 seconds before starting the zone.
22
ADVANCED FEATURES - AUTO MODE
The EZ Pro ™ Jr. incorporates Signature's ManualAdvance feature in the
MANUAL procedure. ManualAdvance allows you to cease the currently
running zone and immediately advance to any new zone you select.
With the MANUAL or CYCLE procedure running a zone, Press SELECT
to advance to a new zone. The last entered run time will be displayed.
Press ADJUST to enter a new run time for the new zone (the controller
will delay 5 seconds before starting the new zone).
NOTE: Once the zone has started running, the run time cannot be
adjusted without deselecting and reselecting the zone.

Run a Program Cycle Manually

Turn the large dial to the CYCLE position. The current program letter
will flash. To change to a different program, turn the PROGRAM dial to
the desired program (A, B, or C). The controller will delay five seconds
before starting the selected program. After running, the controller
resets to the AUTO procedure.
NOTE: CYCLE runs your current program immediately.
You can ManualAdvance through the zones.
23