Set Master Valve Or Pump; Turning The Controller Off - Signature Control Systems, Inc. EZ Pro Jr. 8300 Series Installation And Programming Manual

PROGRAMMING INSTRUCTIONS-PROGRAM MODE
Set Master Valve or Pump Delay
You can delay the time between when the Master Valve/Pump turns on
and the time the zones start. Turn the large dial to Zone Run Times.
Press both the SELECT '+' and SELECT '–' keys together. Use the
ADJUST '+' or '–' key to adjust the time delay. The LCD will show the
time of the delay (Adjustable between 1 second – 30 minutes) with
"del" underneath. To return to setting the Zone Run Times, press both
the SELECT '+' and SELECT '–' keys together.
NOTE: The Master Valve/Pump Delay will be the same for all 3
programs (A, B, and C).
PROGRAMMING INSTRUCTIONS - AUTO MODE
Set the Rain Sensor Bypass
The EZ Pro ™ Jr. is equipped with a Rain Sensor Bypass. This will cause
the controller to water even if the rain sensor is tripped. To activate
bypass the controller must be in AUTO Mode. While in Auto Mode
press both the SELECT '+' and SELECT '–' keys together. The Sensor
Suspend symbol will flash. To deactivate Press both the SELECT '+'
and SELECT '–' keys together, while in AUTO Mode. This will cause the
Sensor symbol to stop flashing and show the current rain sensor
status.
NOTE: Rain Sensor Bypass will remain on until it is deactivated.
20
PROGRAMMING INSTRUCTIONS-OFF MODE

Turning the Controller Off

Turn the MODE dial to the OFF position. This suspends all watering
operations (including manual/test procedures) from operating. The
clock continues to maintain the current time and date and your
program(s) is retained until you want to run your program(s) again.
To run your program, turn the MODE dial back to the AUTO position.
21