Mounting On The Shaft; Adaptation To The Spindle Pitch - ELGO Electronic HWD15 Series Operating Manual

6.2

Mounting on the Shaft

A
Figure 4: Stud bolts for fastening
Method:
1. Place the HWD15 on the shaft so that the two 30 mm long M4 stud bolts (A) fit into the prepared fixing
holes (drilling distance 40 mm).
2. Fix the HWD15 on the shaft by tightening the two grub screws (B) with 2 mm hexagon socket, which
are attached to the side of the hollow shaft body (C).
3. Finally fix the two M4 studs bolts (A) with corresponding nuts.
6.3

Adaptation to the Spindle Pitch

Calculate the correct pulse multiplication factor for the HWD15 according to the spindle pitch as follows:
Spindle pitch : 1250
Example for a pitch of 5 mm: 50 : 1250 = 0,04 (factor)
Enter the calculated factor in parameter P08 (see  6.7).
C
Figure 5: Hollow shaft body with grub screws
- 11 -
Installation and First Start-Up
B