Product Features; Application Examples - ELGO Electronic HWD15 Series Operating Manual

3 Product Features

The battery-operated measuring and display system HWD15 provides a hol-
low shaft (Ø 20 mm) and is directly attached to the spindle. The position is
detected by the integrated sensor and displayed on the LCD display.
Due to its housing with a stable rear wall and flange option including torque
support, the HWD15 is a robust measuring system. However, the mechanical
loads should be absorbed by the spindle. The hollow shaft rotates in a
maintenance-free plain bearing.
The extensive basic functions and parameters allow a wide range of applica-
tions. For example, the display can easily be adapted to the respective spindle
pitch (see  6.3). The device provides a common baby cell (good quality). So
the system operates within 12 months of continuous operation.
NOTE!
In the power-off mode the movements or adjustments of the magnetic sensor are not covered!
A referencing has to be performed after the start of operation (at a required mechanical posi-
tion, the indicator must be set to ZERO or to a defined reference value).
NOTE!
Independent of the setting in P07 (see  6.7), the basic resolution of the HWD15 is
0.01mm). All settings of the multiplication factor refer to this resolution!
3.1

Application Examples

Typical applications for the HWD15 are for example:
Manual and motorized adjustment units

Digital measurement of handwheels

Valve adjustments

Wrapping fixtures

- 7 -
Product Features
Figure 1: HWD15