Table of Contents
Advertisement
DR5200
8.6 Troubleshooting
INFORMATION!
Modifications to the device are not permitted.
•
Only approved personnel can repair the device.
•
If you find a problem, please contact your local representative. If the device must go back to the
manufacturer, refer to "Returning the device to the manufacturer" in this supplement.
Send a report to the manufacturer if there is a failure that is related to functional safety. If you
find a problem, please contact your local representative. If the device must go back to the
manufacturer, refer to "Service" in the handbook (document [N1]).
8.7 Returning the device to the manufacturer
8.7.1 General information
This device has been carefully manufactured and tested. If installed and operated in accordance
with these operating instructions, it will rarely present any problems.
WARNING!
Should you nevertheless need to return a device for inspection or repair, please pay strict
attention to the following points:
Due to statutory regulations on environmental protection and safeguarding the health and
•
safety of the personnel, the manufacturer may only handle, test and repair returned devices
that have been in contact with products without risk to personnel and environment.
This means that the manufacturer can only service this device if it is accompanied by the
•
following certificate (see next section) confirming that the device is safe to handle.
WARNING!
If the device has been operated with toxic, caustic, radioactive, flammable or water-endangering
products, you are kindly requested:
to check and ensure, if necessary by rinsing or neutralising, that all cavities are free from
•
such dangerous substances,
•
to enclose a certificate with the device confirming that it is safe to handle and stating the
product used.
DR5200-LM SIL2 Issue 2
www.drexelbrook.com
SERVICE
8
26
Advertisement
Table of Contents
