Operating Instructions And Tips; Setting The Cutting Heights - Challenge CLMF2031A Original Manual

Operating Instructions & Tips

Setting the Cutting Heights

9a
IMPORTANT! Set the cutting height only when the motor is switched off and the power cable has
been disconnected.
The cutting height is adjusted as shown in Figs. 9a and 9b. To do this, turn the hub cap anti-clockwise
to release the bolt (Fig. 9a) and remove the hub cap with the bolt and wheel. The wheels can now be
fitted in position 1, 2 or 3 to suit the required cutting height. Fit all four wheels at the same height so
that the cutting blade rotates parallel to the lawn.
Position
1
2
3
Before you begin to mow, check to ensure that the blade is not blunt and that none of the fasteners
are damaged. To prevent any imbalance, replace blunt and/or damaged blades. To carry out this
check, first switch off the motor and pull out the power plug.
9b
Cutting height
25 mm
40 mm
60 mm
Customer Helpline 0343 515 1906
17