Performing A Local Hotsync ® Operation With The Usb Cable - Sony PEG-S320 Add-on Application Operating Instructions Manual

Performing a local HotSync
cable
This section describes how to perform a HotSync
cable (local HotSync), assuming that you have done all the necessary
preparations and installations for your CLIE handheld and your computer.
For the required preparations and software installation, and for information
on performing a HotSync for the first HotSync operation, see the Read This
First manual.
1
Connect the CLIE handheld to the USB cable.
2
On your CLIE Handheld, rotate the Jog Dial™ navigator to
select HotSync and then press the Jog Dial navigator. Or tap
the HotSync
The HotSync screen appears on your CLIE Handheld.
3
Tap the HotSync
The HotSync operation starts.
When the HotSync operation is complete, a message showing the
HotSync completion is displayed on your CLIE handheld.
Note
Do not remove your CLIE handheld from the USB cable until the HotSync operation is
complete. Otherwise the Palm Desktop for CLIE software may not quit normally.
If the HotSync operation does not start
Make sure that the HotSync
computer screen and Local Serial is not selected from the shortcut menu. If the
HotSync icon is not shown in the task tray, click Start, point to Programs, Sony
Handheld, and then click HotSync Manager. Tap the HotSync
handheld to start the HotSync operation.
Chapter3
Exchanging and updating data using a HotSync
®
operation with the USB
icon on the Application Launcher screen.
icon.
icon is displayed in the Windows task tray on your
®
operation
®
operation using the USB
icon on your CLIE
115