Setting The Printing Parameters; Selecting The Communication Port; Setting The Print Mode; Setting The Baud Rate - Symmetry EC Series Operator's Manual

SETTING THE PRINTING PARAMETERS

When "F3 SEr" is displayed, press [Zero] to view the first printing
parameter.

Selecting the communication port

• The selected port, for example "S 232" will be displayed.
• Currently, only RS-232 interface is available and the balance
is set with this port only.
• Press [Zero], to view the next printing parameter.

Setting the print mode

• The current setting of the print mode is displayed,
• Press [Unit] to cycle through the other options.
• The following options are available:
P1 Prt
P2 Con
P3 AUT
• Press [Zero], to view the next printing parameter.

Setting the baud rate

• The current baud rate setting will be displayed.
• Press [Unit] to cycle through the other options.
• The following settings are available:
b
b 1200
b 2400
b 4800
b 9600
• Press [Zero] to view the next printing parameter.
The balance sends the accumulated weights to the
communication port, whenever the [Print] key is pressed.
It will set the RS-232 interface to print the weights
continuously and the accumulation function is disabled.
The weighing results will be sent to the communication port
automatically whenever a weight is placed on the platform.
600
(default value)
Page 13