Selecting The Units - Symmetry EC Series Operator's Manual

SELECTING THE UNITS

• When "F1 Unt" is displayed, press the [Zero] key to view the
current settings of each unit.
• Press [Zero] again to cycle through the other units along with
their current settings. For example, if "oFF" is displayed with
the weighing unit Carats, the user will not be able to use this
unit while weighing.
• Press [Unit] to change the settings of a particular unit. For
example, to enable the weighing unit Carats, change the
setting to "on" by pressing [Unit] now.
• Use the [Print] key to leave a parameter unchanged.
• While weighing a sample, the display will show the weight
and the units of weight currently in use. To view the weight
in other units (which are enabled), press [Unit].
• The table on the following page shows different units which
are available to the user and the conversion factors for each.
Page 11