Key Descriptions - Symmetry EC Series Operator's Manual

• Turn the power on by pressing the [On/Off] switch located
underneath the balance on the right hand side.
• The unit will display the model number and the software
revision number for a while and then will count down
performing a self-test.
• When ready the display will show zero along with the
weighing unit selected during the last operation.

KEY DESCRIPTIONS

KEYS PRIMARY FUNCTION
Sets the zero point for all
subsequent weighing. The display
[Zero]
shows zero.
Tares the balance. Stores the
current weight in memory as a tare
value, subtracts the tare value from
[Tare]
the weight and shows the results.
This is the net weight.
Enters the percent weighing
function.
[%]
Use this key to enter counting
mode from the normal weighing
[PCS]
mode,
Pressing this key will cycle through
the weighing units which are
enabled. It also scrolls through the
[Units]
options during setting up a
parameter.
To print the results to a PC or
printer using RS-232.
[Print] It also adds the value to the
accumulated memory if the
accumulation function is not
automatic.
SECONDARY FUNCTION
A secondary function is of "Enter" key
for setting
functions.
Pressing [Tare] again will cancel the
tare value.
When in percentage mode, press [%]
key to return to normal weighing mode.
A secondary function allows the user to
return to normal weighing mode while in
counting mode. It also clears the
accumulated value from the memory
when pressed during recalling the total.
Displays the unit weight, total weight
and the count when in the parts
counting mode.
Secondary function is to return to
normal operation when the scale is in a
parameter setting mode.
Page 6
parameters or other