Telemetry; System Setup; Monitor - Spektrum DX8e Instruction Manual

EN
FUNCTION LIST
4 Timer Event and Timer Control Alerts
Press NEXT to select the Timer Event Alerts settings. These
include options for the alerts at every minute for down timers, 1
minute remaining alert, 30 seconds remaining alert, 10 second
to 1 second remining alerts, expiration alert, and every minute up
alert. Press NEXT again to select the Timer Control Alerts settings.
Available options include Timer Start alert, Timer Stop alert, and
Timer Reset alert.

Telemetry

Telemetry is in both the system setup and the function list so you
can access the telemetry functions from either list.
You must power off the receiver and transmitter, then power them
both on to reset the telemetry data. You can reset min/max values
by pressing the CLEAR button.
NEVER change Telemetry settings when the aircraft is powered
on. There is a brief interruption in RF output when exiting the
Telemetry screen, and may cause a "Hold" condition.

System Setup

Use System Setup to enter the System List from the Function list
without turning the transmitter off. A Caution screen will appear
that warns that RF will be disabled (the transmitter will no longer
transmit). Press YES if you are sure and want to access the System
List. If you are not sure, press NO to exit to the main screen and
continue operation.
If you do not press YES or NO, the system will exit to the main
screen and continue operation within approximately 10 seconds.

Monitor

The Monitor screen displays the servo positions for each channel
graphically and numerically. This is useful to verify programming
functions, trim settings, mix directions, etc. The numeric value
is directly relative to the travel adjust and mix values (e.g. 100%
travel adjust equals 100% value in the Monitor).
34
WARNING: Do not press YES unless the model is turned
off or the model is secured.
SPEKTRUM DX8e • TRANSMITTER INSTRUCTION MANUAL