Power Cord Storage - Bissell CleanView 3575 Series User Manual

Power Cord Storage

When you are done using your BISSELL CleanView, return it to the
Upright position and store the Power Cord.
Turn vacuum cleaner off.
1.
Unplug Power Cord by grasping the polarized plug (NOT
2.
the cord) and disconnect from outlet.
Loop Power Cord around Cord Wraps on side of
3.
vacuum cleaner.
Clip molded plug to Power Cord to secure.
4.
How to Maintain Your BISSELL CleanView
To maintain maximum cleaning performance, the following
maintenance steps must be performed:
Empty the Dirt Container when the dirt reaches the "Full"
1.
line on the side.
Check the Upper Tank and Pre-Motor Filters monthly and
2.
clean or replace as needed.
Clean or replace the Post-Motor Filter every
3.
three months.
Empty Dirt Container
The Dirt Container needs to be emptied when the dirt
reaches the "Full" line on the side of the Container.
Unplug cleaner from electrical outlet.
1.
Slide the Lock 'n Seal Lever to the "Unlock" position.
2.
Grasp handle and pull the Dirt Container straight out to
3.
remove from vacuum.
Empty dirt into garbage container.
4.
Put the Dirt Container back in the vacuum and slide the
5.
lever to the "Lock" position.
8
Note: More frequent filter cleaning may be
necessary if you are vacuuming new carpet, fine
dust, or have allergy concerns. Follow the
instructions on the following pages to perform
these simple maintenance steps.
Note: The Dirt Container may be washed in warm
water with a mild detergent. Make sure it is
completely dry before using again.
NOTICE:
While vacuuming, certain
carpets and low humidity
conditions may generate small
static discharges. The discharges
are entirely harmless and are
not associated in any way with
the main power supply.
WARNING:
reduce the risk of electric
shock, turn Power Switch
OFF and disconnect
polarized plug from
electrical outlet before
performing maintenance or
troubleshooting checks.
Tip:
For maximum
cleaning performance,
check and clean or
replace all filters
as suggested.
Unlock
Position
To
Full Line
Lock Position