Handle Positions - Bissell CleanView 3575 Series User Manual

Attach Vacuum Hose and Tools Continued
Slide the Extension Wand and the Crevice Tool together
4.
into the storage clip as shown.
Slide the Dusting Brush Tool into the storage clip as shown.
5.
How To Use Your BISSELL CleanView

Handle Positions

Press the Handle Release Pedal with your foot to place
your CleanView into one of three cleaning positions.
Upright- For storage and above floor cleaning with tools.
1.
Normal Cleaning- Press Handle Release Pedal once. Use
2.
for most household floor cleaning tasks.
Low Cleaning- With the vacuum in normal cleaning position,
3.
press Handle Release Pedal again. Use for reaching under
low furniture such as tables, chairs or beds.
Power Height Adjustment
The Powerfoot/Rotating Floor Brush on your BISSELL CleanView
can be adjusted to clean several floor surfaces.
Place Handle in Upright Position.
1.
Turn Height Adjustment knob to desired setting.
2.
Place the Handle into the Normal Cleaning Position and
3.
the Powerfoot will adjust to the setting chosen.
6
NOTE: For optimal cleaning performance, adjust
to the lowest practical setting. If your cleaner is
difficult to push, adjust to the next higher setting.
Lowest Setting - For bare floors.
Medium Settings - For short and medium
pile carpets.
Highest Setting - For plush pile carpet.
NOTE: You may also adjust the setting while in
the Normal Cleaning Position.
NOTICE:
The Floor Brush will continue to rotate
while you use your vacuum for above
floor cleaning. To prevent carpet damage,
do not lean on the vacuum or let the
Powerfoot tilt forward.
CAUTION:
Before using your vacuum, make
sure that the Dirt Container and
Upper Tank are in locked position
and that both filters (Pre-Motor
and Post-Motor) are in place. Do
not operate your vacuum without
these filters.
1
2
3
Tip:
Before cleaning
under low
furniture, check
area first for
objects that
might harm the
unit or block the
Vacuum Hose.
Tip:
Your BISSELL
CleanView
features a
Quick-Release
Cord Wrap. To
remove the
Power Cord
quickly and
easily, rotate the
Upper Cord Wrap
towards floor,
and slip Power
Cord from Upper
and Lower
Cord Wraps.