Cluster Setup - Fidelis Network Series Quick Start Manual

b. Use the Up and Down arrow keys to select
the system type Collector Controller (or
Collector XA for cluster), and press Enter.
If you need help determining the system
type, see
The system displays a screen with the
message "Congratulations, your CentOS
installation is complete."
c. Click Reboot.
4. Login in to the appliance using console or SSH
-
Via SSH: Directly attach an Ethernet cable from a client system such as a laptop to the
Admin/eth0 port on the appliance. The default IP address is 192.168.42.11/24. Assign a static IP
from the same subnet to the network interface on the client system and connect to the appliance
using SSH.
5. Use these credentials at the login prompt:
-
user: fidelis
-
default password: fidelispass
6. From the command line, run: sudo /FSS/bin/setup
You will be prompted for the SU (fidelis) password
7. Within Setup, select Network Settings.
8. Configure the network parameters for the system and each active network interface.
a. Use the Network Configuration table you prepared earlier.
b. When complete, return to the top menu.
9. When complete, select [OK] to leave Setup.
10. From command line, reboot the system: sudo /fss/bin/shutdown.pl --user admin --reboot
Repeat steps for all appliances being added to the Collector cluster.
11. Use the PING command to verify connectivity between the XAs on their SYNC/eth2
interfaces.

8. Cluster Setup

On the Final Collector XA4 Appliance
If you have not completed setup for the XA4 appliances in section 7 above, or you are adding an
XA4 appliance to the Collector, follow these steps:
1. Login via SSH or KVM console.
2. From the command line, run: su - root -c /FSS/bin/setup
3. Navigate to Collector Settings.
4. At the XA4 count, enter the number of XA4 appliances, and select Ok.
©Fidelis Cybersecurity
Appendix C.
Fidelis Network™ High Capacity Collector
8
QUICK START GUIDE
www.fidelissecurity.com