Appliance Installation - Fidelis Network Series Quick Start Manual

Sample Network Configuration Table
Network Setting
Interface
Hostname (FQDN)
Static IP Address
Subnet Mask
Gateway
Proxy Server
DNS Servers
NTP Servers
Time Zone

6. Appliance Installation

Rack Installation
Install each appliance in an enclosure/location that has necessary power and cooling.
Power
Connect power cables to the power supplies in the back of the appliance.
Network Cabling
Using the connectors and cables described in sections 4 and 5, begin to connect the appliances to
the networks. Refer to the Collector network diagram for this section.
Cable the Collector Controller 10G appliance(s) to the switches:
1. Connect Admin (eth0) port to the "ADMIN" switch port
2. Connect DB (eth1) port to the "DB" switch port
3. Connect the iLO port to the ADMIN (or ILO) switch port (optional)
4. Repeat for each Collector Controller.
Cable the Collector XA4 Node appliances to the switches:
1. Connect Admin (eth0) port to the "ADMIN" switch port.
2. Connect DB (eth1) port to the "DB" switch port.
3. Connect SYNC (eth2) port to the "SYNC" switch port.
4. Connect the iLO port to the ADMIN (or ILO) switch port. (optional)
5. Repeat for each Collector XA.
©Fidelis Cybersecurity
Admin/eth0 DB/eth1
collector-xa1.organization.net.
10.1.2.3 192.168.1.3
255.255.252.0 255.255.255.0
10.1.2.1
Fidelis Network™ High Capacity Collector
Assignments
SYNC/eth2
172.16.1.3
255.255.255.0
10.5.6.7
8.8.4.4, 8.8.8.8
pool.ntp.org.
UTC (+0)
6
QUICK START GUIDE
iLO/IMM
10.2.3.4
255.255.252.0
www.fidelissecurity.com