Advertisement
manufacturer and the seller do not accept responsibility for any damage due to incorrect
electrical installation.
Battery cut-out 12V/24V DC operation
The control system allows for the voltage cut-out to be set to three (3) different settings
depending on the environment & situation that the appliance is being operated in. Low voltage
supply to the appliance can result in poor cooling performance and damage to the battery.
when using 12V DC, the digital readout will show the factory setting 10.0V DC. To ensure that
suitable battery voltage can be maintained the controller has been programmed for three (3) cut-
out levels-11.8, 10.7 & 10.0V DC.
When using 24V DC, the digital readout will show the factory setting 22.2V DC. To ensure that
suitable battery voltage can be maintained the controller has been programmed for three (3) cut-
out levels-25.0, 23.5& 22.2V DC.
To set the battery cut-out to the required level follow these steps:
①.Push the "SET"button twice, the digital readout "G"will show the current setting.
②.Push the "B"or "C"to adjust the setting. The display will flash four (4) times with the
selected setting. To check press button "SET" once and the selected setting will flash and then
return to the current voltage input.
When the appliance is disconnected from the power source the battery cut-out remains at its last
setting.
Temperature adjustment
When the freezer is connected to the power outlet, press the"set"button, the LED will display the
factory pre-set freezing temperature of -18℃.
Temperature adjustment:
①.Press the"set"button.
②.While the LED is flashing, press "+"or "–"button to reach the required temperature.
Speed model setting
Press "speed" button to change from High、Auto、Low speed.
Power model setting
Press button " " to start and stop the unit. When the until is power off, the LED will display
OFF.
Encoded remote(Allowing you to change the frequency on your remote)
This will allow you to set the remote to match the code on your fridge. Meaning you cannot
change the temperature settings on another unit at the same time.
To change the code on your unit, hold the – button in for 10 seconds the code will flash that the
unit has been set to. Then press the up or down arrow to change the code.
To match the code on the remote, hold the down arrow for 10 seconds until the code flashes on
the remote. Press the up or down arrow to match the code that you have .
Advertisement
