Advertisement
Identification
1. Latch
2. Foamed door
3. Steel basket
4. Door gasket
5. Handle
6. Door inner liner
7. PVC door frame
8. Side handle
9.Door hinge
10. Feet
11. Grill
12. AC connector
13. DC connector
14. Temperature controller
15. Drain plug
16. Fuse
Temperature controller diagram:
A. SET: Set button
B. Button for adjusting temperature +
C. Button for adjusting temperature-
D. Running indicator: green when running normal.
E. Button for power ON/OFF
F. Alarm indicator: when the power is too low, the battery indicator will flash
G. LED indicator: display the temperature (℃), voltage and battery condition
H. Temperature read out freezer or fridge
I. SPEED: Press SPEED button to switch from High speed, Auto,Low speed.
a)High：Red LED on, Compressor running at MAX speed, approximate 3500rpm.
b)Auto：Yellow LED on, Compressor Speed controlled electronically.
c)Low: Speed：Green LED on, Compressor running at MIN speed, approximate 2400rpm.
Movement and Installation
When moving the freezer, the angel between the cabinet and the ground should not be less than
45°in order to protect the compressor and refrigeration system.
Position the freezer in a dry and well-ventilated area. Away from heat sources such as direct
sunlight, Heaters, stoves and corrosive gases.
The normal operation of the freezer depends on the heat radiation of the condenser. For the
initial use, the packing foam must be taken off and at least 150mm space must be left around the
freezer.
The appliance must be earthed and connected to a suitable 230V or 12V/24V socket. The
Please read this instruction manual before use
Advertisement
