Metz SCA 3302 M7 User Manual page 31

the flash unit first automatically switches to the
Manual M and "GnC" mode (see 4.18.2).
• The camera must be set to "Wireless Mode" or
"WL" (see camera's operating instructions). With
Dimage 7i and 7Hi in combination with the
mecablitz 54MZ-..., 70MZ-... and 76 MZ-5 digi ,
the flash unit then automatically switches to TTL
mode.
• The controller and the slave(s) must be set to the
same remote address! With the mecablitz 44
MZ-2 only "Ad1" is possible.
• The mecablitz can only be used as a slave and
not as a controller.
• Since the mecablitz (slave) is controlled by weak
flashes from the controller, the ambient light level
should be as low as possible, and the flash-to-
subject distance should not be wider than 5 m.
• The sensor of the SCA 3302 adapter must be
aligned in such a manner that it can receive the
signals from the controller.
• The remote mode does not allow the use of shut-
ter speeds faster than 1/60th sec. (on some
cameras only 1/45th sec.).
• The secondary reflector (where applicable) of the
mecablitz must not be switched on.
• The AF measuring beam of the mecablitz will
start flashing when flash readiness has been
achieved.
• The camera's Eye-Start system must not be
activated so that a test flash can be fired with the
camera's SPOT or AEL button.
31