Metz SCA 3302 M7 User Manual page 25

play. Turn the setting disk until "HSS" is indicated
on the display. Then push the setting disk in the
direction of the arrow for storage. Storage will be
automatic after 5 seconds if the setting disk is not
pushed. "TTL" or "M" and in addition "HSS" are
now indicated on the LC display of the mecablitz. In
the manual mode of the mecablitz the light output
can be adapted to the individual shooting situation
by setting a partial light output level of P1/1 to
P1/256.
The HSS flash mode can only be activated if
the mecablitz is mounted on an HSS-compa-
tible camera. The camera must be switched on
and at least one exchange of data should have
been completed between mecablitz and
camera. For this purpose just lightly touch the
camera's shutter release without tripping the
shutter (please also refer to the operating
instructions for the given mecablitz).
When high-speed synchronisation is activated
on the mecablitz (HSS is displayed) it will be
completed only if the camera works with a
manually or automatically selected shutter
speed that is faster than the camera's synch
speed.
Due to physical reasons, the HSS flash mode
significantly reduces the guide number and
the maximum flash range of the mecablitz! You
should therefore pay attention to the maximum
flash range indicated on the LC display of the
mecablitz or refer to the operating instructions
and technical specifications of the flashgun.
25