Safety Instructions; General Notes; Eu Conformity; Approval According To The Iecex Scheme - Siemens SITRANS FX330 Ex-i Additional Operating Instructions

SITRANS FX330

1.1 General notes

This additional instruction applies to explosion-protected versions of vortex flowmeters with
protection type intrinsic safety "i", equipment category II 2 G and EPL Gb.
It completes the standard manual for the non-explosion protected versions.
The information given in this instruction contains only the data relevant to explosion protection.
The technical details given in the manual for the non-explosion protected versions remain
unchanged unless they will be excluded or replaced by this instruction.

1.2 EU conformity

The manufacturer declares with the EU declaration of conformity on his own responsibility
conformity with the protection goals of directive 2014/34/EU for use in hazardous areas with gas.
The EU declaration of conformity for the equipment category II 2 G is based on the EU type
examination certificate of the KIWA ExVision:
The "X" after the certificate number refers to special conditions for safe use of the device, which
have been listed in these instructions.
If necessary, the EU type examination certificate can be downloaded from the manufacturer's
website.

1.3 Approval according to the IECEx scheme

Conformity of the vortex flowmeter for use in hazardous areas with gas was tested in accordance
with the "IECEx Certification Scheme for Explosive Atmospheres" according to IEC 60079-0 and
IEC 60079-11.
The number of the IEC certificate is:
The "X" after the certificate number refers to special conditions for safe use of the device, which
have been listed in these instructions.
If needed, the IEC certificate can be downloaded from the manufacturer's website.
09/2018 - A5E39673922-AB

SAFETY INSTRUCTIONS

KIWA 16 ATEX 0044X KIWA 16 ATEX 0044X KIWA 16 ATEX 0044X KIWA 16 ATEX 0044X
IECEx KIWA 16.0021X IECEx KIWA 16.0021X
IECEx KIWA 16.0021X IECEx KIWA 16.0021X
www.siemens.com/flow
1
3