Starter Test - Matco Tools MBT2415 Instruction Manual

Press key to continue and the display will show: (Fig.39):
Check the battery ratings and enter it as described earlier and the results will show as an example below
(Fig. 40 and Fig.41):
Fig.40
Fig.40 - Results shown [Recharge and test again], indicates that the battery has to be fully charged first before
repeating the test. Reason: State of Charge: 11.09V is too low.
Fig.41 - Results shown [To replace], this means that the battery needs to be replaced as its internal plate
resistance [Int. R] 19.21m is higher than 15 m limit.
Pressing the

Starter Test:

This test is only available in
battery system during starting and also the starter condition.
1. With engine OFF, place
the hand brake.
2. Connect the tester to the battery terminals and the displays will light up as shown below:
Wake up screen
10.85V
Fig.38
Fig.39
8
11.09 V
120 CCA
18.91 m
key at any moment will exit and return back to the main menu display.
test and it
the vehicle transmission in NEUTRAL for Manual and PARK for Automatic then apply

Select Continue test
and press
State of Charge (SOC)
12.65 V
Fig.41
120 CCA
19.21 m
actually checks the cranking effectiveness of the 12V or 24V

Select Automotive
key
and press key
1812411-11
17