Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Honeywell Galaxy Power RIO
Summary of Contents for Honeywell Galaxy Power RIO
- Page 1 Galaxy Power RIO Installer Manual Honeywell Security...
-
Page 2: Power Supply Unit
The Galaxy Dimension Power Supply Unit is available in 2 variants. The Galaxy Power RIO consists of a Power Block and a Control Unit that includes an on-board RIO. The Galaxy Power Unit consists of a Power Block and a Control Unit without the on-board RIO. -
Page 3: Installation Instructions
Power Supply Unit (cont’d) Galaxy Dimension Installer Manual Installation Instructions The installation and wiring must be performed by a competent engineer. The Galaxy Dimension Power Supply Unit must be connected to the a.c. mains supply (230/240 Va.c. 50Hz) via a fused connection outlet. The fuse in the mains outlet must not exceed 3A. -
Page 4: Battery Test
Power Supply Unit (cont’d) Galaxy Dimension Installer Manual Battery The minimum capacity battery to supply the PSU is 1x 7Ah. The maximum capacity battery to supply the PSU is 2 x 17Ah. Battery Test A battery test on full load is automatically performed once an hour and during the Engineer Mode exiting procedure.
Need help?
Do you have a question about the Galaxy Power RIO and is the answer not in the manual?
Questions and answers
May you confirm the current on AC side (230Vac) si more or less 0,22A? may you confirm the heat dissipation to be considered?
The current on the AC side (230Vac) for the Honeywell RIO is not directly stated. However, the manual specifies that the unit must be connected via a fused connection outlet with a fuse not exceeding 3A. Therefore, the maximum current on the AC side is up to 3A.
The heat dissipation to be considered is not specified in the provided information.
Answer: Maximum AC current is up to 3A; heat dissipation is not specified.
This answer is automatically generated