Specifications; Regular Inspection And Maintenance; Before Each Ride - Cake Kalk Manual

2.4 Charging
Charging
When charging the bike, do the following steps.
ALWAYS read the charging manual before charging.
1. Make sure that the battery is connected to the bike (both connectors
from battery, both the big red one and the small yellow one)
2. Disconnect the killswitch
3. Turn on the master switch (pointing upwards)
4. Plug the charger into the outlet (220V)
5. Plug the charger into the bike (charger connector can be found under the
bike, close to the triple clamps)
When the charger is connected, it will show a red light. When the charging
is done, it will light in green. When the charging is finished, don't forget to
put the rubber cap on the connector, not to break it during riding.
• Never charge the bike without supervision.
• Never let the bike charge unattended.
• Never use the charger in any other application than with the CAKE bike.
• Never use any other charger than the original CAKE charger.
• Never have the kill switch on the handlebar connected as the bike can be
turned on and ridden while the charger is connected. This can cause seve
re injuries to people or properties.

2.5 Specifications

Kalk, Limited edition
Top speed: 80 Km/h
Torque: 42Nm
Power:
Ratio: 12/80 direct drive
Battery capacity: 50 Ah
Wheel size: 24" Bicycle
Fork: 38mm Öhlins, CAKE specific
Travel: 203mm

3. Regular inspection and maintenance

3.1 Before & after each ride
To make sure that your bike is always in good condition and avoid injury or
damage, please make sure to always take care of your CAKE Kalk bike by
the following steps.
• Check the wheels
• Check the chain
• Clean your bike (see Chapter 5.2 - Cleaning)
• Check suspension
• Check that the headset is properly tightened