Cake Kalk Manual page 11

• Start with making sure that the bike is properly charged through the LEDs
on the dashboard. As the battery gets close empty, the battery cells inside
loose the ability to have a high discharge (full power).
• Please be careful, when checking if the controller or motor is overheated
as you could get burned. This will be showed by the Dashboard Temp LED
glowing in RED. If it does, please let the vehicle cool down sufficiently to
avoid permanent damages to either the motor, controller or battery.
The dashboard is blinking in weird colours.
• The Dashboard is blinking in different colours when driving. Check if this
problem occurs more regularly when you are on brake mode #3.
This can be caused by high current between the battery and controller
as the current is switching between being discharged (when driving) and
charging (motor brake regenerating and charging the battery). This is
then caused by electrical interference and can happen from time to time.
• If you have questions, get in contact with us directly.
My charger doesn't work.
• Follow the instructions and functions of the charger under
chapter 2 "Charging".
• Check the small fuse on the charger. Change to a new one if necessary.
• If the charger does not work as usual. Get in contact directly with CAKE,
describing the issue in detail.
My motor is sounding strange or won't spin.
• If the motor sounds strange when giving throttle and does not run pro
perly. Please turn the bike off and do not give the bike any throttle as the
motor can still be overheated by the battery current. This could
potentially happen if the sensors in the motor gets humid/water.
The issue is temporary, please put the bike inside to let it dry for 24 hours.
Get in touch with CAKE directly regardless if the issue disappears or not.
Oil has started leaking from the fork
• This can happen if the bike is stored for too long without being ridden.
When the suspension is static for too long, the gasket in-between the
moving pipes can dry out. If this happens, wipe the oil off, test the
suspension to see if it works normally and see if the leaking disappears.
If it doesn't, get in contact with CAKE directly.
Theres play between the front suspension and the frame.
• This is due to the that the headset is not tightened properly/has
become loose.
• Put the bike on a stand.
• Start with unscrewing the 4 screws on the upper tripple clamp so they
become loose (don't unscrew completely).
• Push the lower tripple clamp upwards so the head tube get full contact
with the frame. The loose the headset bolt just a bit before tightening
it hard.
• Tighten the screws on the upper tripple clamp and test the suspension
to see if the play is still there.
• Repeat if necessary.
• Get in contact with CAKE if the issue doesn't resolve after the
actions above.