Sony MZ-B50 Operating Instructions Manual page 36

Symptom
No sound comes
through the
headphones/
earphones.
An MD is not
played from the
first track.
The recorder does
not play normally.
Playback sound
skips.
Sound has a lot of
static.
Cannot find the
track marks.
The clock loses
time or the display
flashes.
The recording date
was not stamped
onto the disc.
36
-GB
Cause/Solution
• The headphones/earphones plug is not firmly connected.
, Plug in the plug of the headphones/earphones firmly to the
remote control. Plug in the plug of the remote control firmly to
i.
• Volume is too low.
, Adjust the volume by turning VOL.
• Dirty plugs.
, Clean the plug on the end of the headphones/earphones cord
and the plug on the end of the remote control cord.
• Disc playing stopped before it came to the last track.
, Press .REVIEW/AMS repeatedly or open and close the lid
once to go back to the beginning of the disc, and restart playing
after checking the track number in the display.
• Repeat play is selected.
, Press PLAY MODE repeatedly until the
disappears from the display.
• The recorder is placed where it receives continuous vibration.
, Put the recorder on a stable place.
• A very short track may cause sound to skip.
• Strong magnetism from a television or such device is interfering
with operation.
, Move the recorder away from the source of strong magnetism.
• You pressed XPAUSE after pressing .REVIEW/AMS or
>CUE/AMS.
, Press XPAUSE before pressing .REVIEW/AMS or
>CUE/AMS.
• The built-in battery for the clock is weak. Note that the clock may
gain or lose up to about 2 minutes per month under normal
condition.
, Insert new dry batteries and leave them for about more than
two hours to charge the built-in battery. After charging, set the
clock again (page 19).
• The clock is not set.
, Set the clock (page 19).
indication