Table of Contents
Advertisement
D
E
F
4. Slowly move it to the left side. Do not apply
force to the wire of the spark plug
connector (F) and to the thermocouple
conductor (E).
5. Release the burner injector (D) with a 7 mm
socket spanner and replace it with a
different one which is necessary for the type
of gas you use.
Refer to "Technical information" chapter.
6. Assemble the burner in a reverse sequence.
Replace the gas type sticker near the gas
supply ramp with the one related to the new gas
type.
The gas oven burner does not need any primary
gas regulation.
Make sure that the gas supply
pressure of the appliance obeys the
recommended values.
If the supply gas pressure is
changeable or different from the
necessary pressure, you must fit an
applicable pressure adjuster on the
gas supply pipe.
Building in
• Only set up the appliance in a kitchen or in a
kitchen-dining room. Do not set up the
appliance in a bathroom or a bedroom.
• You can install the appliance "built-in" or
"built-under". The dimensions of the built-in
cabinet must agree with the related
illustrations.
18
50
min. 550
110
590
min. 560
65 cm
2
x2
2
130 cm
min. 550
110
600
min. 560
2
65 cm
130 cm
x2
5
• There must be a clearance of minimum 4 mm
between the top surface of the appliance
and the inner top of the cabinet.
• When you install the appliance "built-under"
(below a hob), install the hob before the
oven unit.
• The materials must be resistant to a
temperature increase of minimum 60 °C
above the ambient temperature.
• There must be a continuous air supply
around the oven in order to not have the
oven become too hot.
• For correct operation, the oven cabinet must
have a minimum opening of 130 cm² in the
front or on the sides (a minimum of 65 cm²
for each side). The manufacturer
recommends a 130 cm² opening in the front
548
21
558
114
16
573
594
5
3
min. 4 mm
548
21
558
114
16
573
2
594
3
www.zanussi.com
589
594
589
594
Advertisement
Table of Contents
