Emerson Rosemount 248 Reference Manual page 53

Reference Manual
00809-0100-4825
Table 4-3: Field Communicator Diagnostic Messages
Message
Incomplete field
Looking for a device
Mark as read only variable on
hotkey menu?
No device configuration in
configuration memory
No Device Found
No hotkey menu available for
this device.
No offline devices available.
No simulation devices
available.
No UPLOAD_VARIABLES in
ddl for this device
No Valid Items
OFF KEY DISABLED
Online device disconnected
with unsent data. RETRY or
OK to lose data.
Out of memory for hotkey
configuration. Delete
unnecessary items.
Overwrite existing
configuration memory
Press OK.
Restore device value?
Save data from device to
configuration memory
Saving data to configuration
memory.
Sending data to device.
Rosemount 248 Temperature Transmitter Reference Manual
Description
The value entered is not complete for the variable type.
Polling for multidropped devices at addresses 1–15.
Asks whether the user should be allowed to edit the variable from
the hotkey menu if the item being added to the hotkey menu is a
variable.
There is no configuration saved in memory available to re-
configure off-line or transfer to a device.
Poll of address zero fails to find a device, or poll of all addresses fails
to find a device if auto-poll is enabled.
There is no menu named "hotkey" defined in the device description
for this device.
There are no device descriptions available to be used to configure a
device offline.
There are no device descriptions available to simulate a device.
There is no menu named "upload_variables" defined in the device
description for this device. This menu is required for offline
configuration.
The selected menu or edit display contains no valid items.
Appears when the user attempts to turn the Field Communicator
off before sending modified data or before completing a method.
There is unsent data for a previously connected device. Press RETRY
to send data, or press OK to disconnect and lose unsent data.
There is no more memory available to store additional hotkey
items. Unnecessary items should be deleted to make space
available.
Requests permission to overwrite existing configuration either by a
device-to-memory transfer or by an offline configuration. User
answers using the softkeys.
Press the OK softkey. This message usually appears after an error
message from the application or as a result of HART
communications.
The edited value that was sent to a device was not properly
implemented. Restoring the device value returns the variable to its
original value.
Prompts user to press SAVE softkey to initiate a device-to-memory
transfer.
Data is being transferred from a device to configuration memory.
Data is being transferred from configuration memory to a device.
Operation and Maintenance
(continued)
May 2019
53