Safety Instructions For Commissioning; Safety Instructions For Operation - MAHA TWIN F IV 3.0 Series Original Operating Instructions

6
• be trained and instructed in writing,
• have read and understood the operating instructions, especially the instructions
what to do in the event of defects or malfunctions,
• be on record as having been instructed in safety guidelines,
• have practical experience in working with vehicle lifts and the hazards inherent
in such equipment.
Pos: 19 / Tec hnische Dokume ntation/Alle Geräte/Übersc hriften/ Überschrifte n 1.1/S/Übersc hrif t 1.1: S ic herhe itsvorschr iften f ür die Inbe trieb nahm e @ 6\m od_1174482269156_ 75.docx @ 76838 @ 2 @ 1
1.6

Safety Instructions for Commissioning

Pos: 20 / Tec hnische Dokume ntation/Hebetechnik/00 HBZ Alle/Inhalte/Inha lt: S icherhe itsv orschrif te n f ür die I nbetriebna hme H BZ_12pt @ 47\mod_ 1483524035338_75.d ocx @ 2804458 @ @ 1
• The lift shall be installed and commissioned by authorised service personnel
only.
• Use personal protective equipment.
• All safety features must be checked for proper function at commissioning.
• The control desk (if present) shall not be installed in the danger zone of the lift.
• The standard lift version shall not be installed and commissioned in hazardous
locations, outdoors, in moist rooms (e.g. car wash) or outside a temperature
range of 5...40 °C (41...104 °F).
Pos: 21 / Tec hnische Dokume ntation/Alle Geräte/Übersc hriften/ Überschrifte n 1.1/S/Übersc hrif t 1.1: S ic herhe itsvorschr iften f ür den Betrieb @ 6\m od_1174482268953_ 75.docx @ 76826 @ 2 @ 1
1.7

Safety Instructions for Operation

Pos: 22 / Tec hnische Dokume ntation/Hebetechnik/00 HBZ Alle/Inhalte/Inha lt: S icherhe itsv orschrif te n f ür den Be trieb H BZ_12pt @ 47\mod_ 1484658648165_ 75.docx @ 2810948 @ @ 1
• Observe the detailed operating instructions.
• Observe all accident prevention regulations.
• Use personal protective equipment.
• The standard lift version shall not be operated in hazardous locations, outdoors,
in moist rooms (e.g. car wash) or outside a temperature range of 5...40 °C
(41...104 °F).
• To ensure safe operation, check the functionality of all safety devices before
using the lift.
• The control desk (if present) must be positioned in such a way that there is an
unobstructed view to the complete working area and the emergency stop can
be accessed at all times.
• All structural parts of the equipment must be visually checked at regular
intervals.
• Supply of suitable illuminating devices is the owner's/operator's responsibility.
• Do not allow anyone to stay in the danger zone when driving on or off the lift.
• Lifts with cylinder and runways: when lifting vehicles with a short wheelbase,
make sure that one axle is in front of the lifting cylinder, the other behind it.
• Lifts with wheel-free jack: before driving on or off the lift or wheel-free jack,
make sure the jack is in bottom position.
• If the operator is unable to see all parts of the danger zone, a trained second
person must monitor such areas.
BA083101-en