Wnc Module Firmware; Arm Keil Ide; Keil Software Download; Figure 6 - Block Diagram Of Assembled System - Avnet AT&T IoT Starter Kit Getting Started Manual

The system-level block diagram for this version of AT&T IoT Starter Kit is shown below:

WNC Module Firmware

The WNC M14A2A module has been factory programmed with IMA3 firmware for LTE Cat-M1 operation.
If there is a need to check this firmware version or reprogram the module, please refer to Appendix-A
at the end of this document

ARM Keil IDE

The firmware for the STM32L4 Discovery Kit IoT Node is developed, compiled and debugged using
Arm® Keil MDK, a full-featured IDE with advanced debugging capabilities and CMSIS library support for
thousands of Arm® Cortex-M devices. More detail about this professional IDE is available at:
http://www2.keil.com/mdk5

Keil Software Download

Download the Keil tools as follows:
1. Go to: https://www.keil.com/demo/eval/arm.htm
2. Provide the information requested in the form there and click Submit
3. Follow the instructions on the page which follows that, to download and install the Keil tools...
F 6 - B D
IGURE LOCK IAGRAM OF
A
SSEMBLED
Page 9
S
YSTEM