Simulaids SMART STAT BASIC 8002 Instruction And Care Manual page 24

Running a Session, Recording a Scenario:
A session is a timed and logged series of events based upon how the instructor
challenges the student(s) and how the student(s) responds to the challenges.
To start a recording session, connect to a patient simulator from the Home screen
1. Tap the Patient Simulator icon
2. Turn on the Control button
3. Select the line to highlight it blue.
4. Tap Continue once (wait for it) in the upper right corner.
5. This displays the Student screen.
6. Tap Continue to connect the patient simulator to the iPad.
7. Tap the Home in the upper left hand corner
8. Tap the Scenario icon
9. Select a scenario
10. Tap Continue
11. Select the patient simulator you connected to in step 1.
12. Tap Continue
13. Select Student/Team
14. Tap Continue
15. Tap the default preset green arrow
16. Start scenario
To insert a scenario into a recording session, tap the Home button in the upper left of
the screen.
The control screen is displayed and the scenario is outlined in the Ticker strip at the
bottom of the screen. Within the ticker strip, and at each feature change, is a
countdown clock in parenthesis [-5]. Observe these clocks to know when the next
change will occur according to the scenario programming. (By unchecking a feature that
has not played will cause it to be skipped.)
Below the ticker strip are the play, pause and stop buttons. Pause the session and the
elapsed time clock will continue to run, but the log clock stops until you resume by
tapping the pause icon again. If you stop a session recording by tapping the white
rectangle, all features and session recordings stop.
Countdown
Clock
Ticker
Scenario Name
24
Scenario
select
Scenario Stop
Stop Pause
Clock