Troubleshooting - Amcor SF8000E-V3 User Manual

TROUBLESHOOTING

Do not repair or disassemble the air conditioning. Unqualified repair will invalidate the warranty and may
lead to failure, causing injuries and property damage. Only use it as directed in this user manual and
only perform operations advised here.
Problems
The air
conditioning
does not work.
The cooling or
heating effect
is not good
Loud Noise
Compressor
does not work.
The remote
control does
not work.
Displays 'E1'.
Displays 'E2'
If problems not listed in the table occur or recommended solutions do not work, please contact the
service centre.
Reasons
There is no electricity.
The tank full indicator is
illuminated.
The ambient temperature is too
low or too high
In cooling mode, the room
temperature is lower than the set
temperature; in heating mode, the
room temperature is higher than
the set temperature.
In dehumidification mode, the
ambient temperature is low.
There is direct sunlight.
Doors or windows are open; there
are a lot of people; or in cooling
mode, there are other sources of
heat (e.g. fridges)
The filter screen is dirty.
The air inlet or outlet is blocked.
The air conditioning is not placed
on a flat surface.
Overheat protection starts.
The distance between the
machine and the remote control is
too far.
The remote control is not aligned
with the direction of the remote
control receiver.
Batteries are dead.
The pipe temperature sensor is
abnormal.
The room temperature sensor is
abnormal.
Solutions
Turn it on after connecting it to a socket
with electricity.
Discharge the water inside.
Only use to use the machine within
temperature range of 7-35 ℃ (44-95 ℉ ).
Change the set temperature.
The machine is placed in a room with an
ambient temperature of greater than
17 ℃. (62 ℉).
Use curtains to reduce heat from the sun
Close doors and windows; increase air
conditioning power
Clean or replace the filter screen.
Clear obstructions; make sure venting is
correct as described in this user manual
and hose is not bent
Put the air conditioning on a flat and hard
place (to reduce noise).
Wait for 3 minutes until the temperature
is lowered, and then restart the machine.
Let the remote control get close to the air
conditioning, and make sure that the
remote control directly faces to the
direction of the remote-control receiver.
Replace batteries.
Clean filters and restart. Refer to service
centre if issue still persist.
Clean filters and restart. Refer to service
centre if issue still persist.
Page 13 of 15