Troubleshooting - Amcor NanoMax A12000EH Owner's Manual

Never try to repair or dismantle the air condition yourself. Incompetent repairs result in
loss of warranty and can endanger the user and the property.
Problem
No power supply. Make sure the
The air
green light on the plug is lit.
conditioner does
Is the power light flashing?
not function.*
Is the water full LED lit?
The unit is in direct sunlight.
Windows or doors open, many
The air
people or a heat source in the room.
conditioner does
The filter is dirty.
not seem to
Air inlet or air outlet blocked.
perform.
Room temperature lower than the
selected value.
The unit is noisy. Unit stands uneven.
The compressor The overheat protection may be
does not work. activated.
Distance too great.
The remote
Remote control signal not detected
control does not
by the control panel.
function.
The batteries are drained.
* If you plug in the Air Conditioner, and there is no green light on the plug,
press the reset button on the LCDI plug. The green light should be lit,
indicating that the air conditioner is getting power from the electrical outlet.
If the plug continues to trip (which is a USA national safety standard feature)
and the green light goes off, the cord may be damaged preventing you from
resetting the unit. For your safety, contact a licensed electrician.

Troubleshooting

Cause
12
Solution
Connect to a functioning outlet and switch on.
Empty the drain pan.
Close curtains.
Close doors and windows, place an extra air
conditioner.
Clean or replace the filter.
Remove the blockage.
Change temperature selection.
Set at the lowest possible setting: 62°F.
Place on an even, solid surface (less vibrations).
Wait 30 minutes until the temperature has
decreased, then turn on the unit again.
Make sure the remote control is correctly
aimed at the control panel.
Replace the batteries.
RESET
TEST
Reset Button
Test Button
Green Light