Supermicro AOC-MHIBF-m2Q2G User Manual page 35

4. Use the command #mlxfwmanager to extract the "vendor_part id" parametar.
[root@localhost ~]# mlxfwmanager
Querying Mellanox devices firmware...
Device#1:
- - - - - - -
Device Type:
Part Number:
Description:
PSID:
PCI Device Name: /dev/mst/mt4103_pci_cr0
Port1 GUID:
Port2 GUID:
Versions:
FW
PXE
UEFI
Status:
5. To change the add-on card to Ethernet mode (LINK_TYPE=2), please enter
command #mlxconfig -d<vendor_part id> and then key in "y" to apply the new
configuration. (The command below is using the device ID in step 4.)
[root@localhost ~]# mlxconfig -d /dev/mst/mt4103_pci_cr0
set LINK_TYPE_P1=2
Device#1:
- - - - - - -
Device type:
Device:
Configurations:
LINK_TYPE_P1
Apply new Configuration? (y/n) [n]:_
Note: The command above will change Port1 to Ethernet mode. In
changing Port2 to Ethernet mode, replace "LINK_TYPE_P1=2" with
"LINK_TYPE_P2=2" at the end of the command line.
Note: To change the LAN ports from Ethernet to InfiniBand mode, the
command line must specify "LINK_TYPE_P1=1" for Port1 and "LINK_
TYPE_P2=1" for Port2 at the end of the command line.
ConnectX3Pro
Super_Micro_AOC-MHIBF-m2Q2G
Hybrid SIOM 2-port IB FDR CX3-Pro
SM_1171000001000
003048ffffffeb55
003048ffffffeb56
Current
2.42.5000
3.4.0752
14.11.0045
No matching image found
ConnectX3Pro
/dev/mst/mt4103_pci_cr0
3-13
Chapter 3: Installation
Available
N/A
N/A
N/A
Next Boot
IB(1)
New
ETH(2)