Specifications; Setup - Central Machinery 61808 Owner's Manual & Safety Instructions

Specifications

Setup - Before use:
read the EntirE iMpOrtant SaFEty inFOrMatiOn section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
tO prEVEnt SEriOuS inJury FrOM acciDEntaL OpEratiOn:
turn the power Switch of the appliance off and unplug the appliance from its
electrical outlet before performing any procedure in this section.
note: For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
assembly
casters
1. Remove the Lock Washers (24), Flat
Washers (9) and Nuts (28) from the
Caster (31/32) Studs. See Figure A.
Lock Washer (24)
Frame (29)
Figure a
Page 4
Electrical Rating
Capacity
Air Flow
Hose Inlet/Outlet Diameter 4" OD
acorn
nut (26)
Flat Washer (9)
nut (28)
caster (32)
For technical questions, please call 1-888-866-5797.
120VAC / 60Hz / 7.5A
13 Gallons
660 CFM
2. Thread a Nut (28) back onto the
Caster's stud securely.
3. Insert the Caster's stud into a hole at
the bottom of the Frame (29).
note: There are 2 casters with brakes,
install them as desired.
4. Slide a Lock Washer (24) and Flat
Gasket (9) onto the stud. Secure the Caster
in place using an Acorn Nut (26).
5. Repeat steps 2 through 4 above for all Casters.
Item 61808