Table of Contents
Advertisement
SPECIFICATIONS
Motor
RPM
Bag Dimensions
Bag Filtration Ratio
Intake
Exhaust Diameter
FEATURES
1
All ball-bearing balanced armature
2
Locking casters
3
Cast Iron Motor Housing
4
Lockable toggle switch
5
Fan cooled
UNPACKING
When unpacking, check to make sure
that the is intact and undamaged. If any
parts are missing or broken, please call
Harbor Freight Tools at the number shown
on the cover of this manual as soon as
possible.
List of contents
Part
Description
1
Collection Bags
2
Swivel Casters (locking)
3
Hex Wrenches
INITIAL SET UP
INSTRUCTIONS
Read the ENTIRE IMPORTANT
SAFETY INFORMATION section
at the beginning of this manual
including all text under
Item 97869
For technical questions, please call 1-888-866-5797.
120 Volts, 60 Hz, 2HP,
Single Phase, 20 AMPS
Peak,
3450
Top=19-1/2" Dia. x 30"L
Bottom=19-1/2" Dia. x
30-7/8"L
5 Microns
4-3/8" ID (screen & filter)
4-1/2 Inch ID With Screen
Q'ty
subheadings therein before set
up or use of this product.
WARNING
FROM ACCIDENTAL
OPERATION:
Turn the Power Switch of the
tool to its "OFF" position and
unplug the tool from its
electrical outlet before
assembling or making any
adjustments to the tool.
Note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
1.
Your Dust Collector will require
complete assembly prior to use. It
is important that you read the entire
manual to become familiar with the
product BEFORE you use the Dust
Collector. Before assembling the
Dust Collector be sure that you have
all parts described in the Parts List
and Assembly Diagram.
a. Step 1) Place Caster (see Parts List
1) in place on the underside corner
of the Base Plate (3). For all four
2
(4) corners of the Caster (1) insert
4
one Hex Screw (23) through Washer
2
(16) down into Base Plate (3) and
through Caster (1). Thread on Nut
(19). Repeat for the remaining three
(3) Casters (#1).
TO PREVENT
SERIOUS INJURY
ASSEMBLY
Page 8
Hide quick links:
Advertisement
Table of Contents
