Siemens SCALANCE XB108-2 Operating Instructions Manual page 21

Installation
Figure 4-1
To install the device on a 35 mm DIN rail complying with DIN EN 60715, follow the steps below:
1. Place the housing guide of the device on the top edge of the DIN rail
2. Press the device down against the DIN rail until the spring catch locks in place
3. Fit the connectors for the power supply, see the section "Power supply (Page 28)".
4. Insert the terminal blocks into the sockets on the device.
Removal
Figure 4-2
To remove the device from a DIN rail, follow the steps below:
1. Disconnect all connected cables.
2. Release the DIN rail locking mechanism by pressing down on the release button
3. Pull the lower part of the device away from the DIN rail
SCALANCE XB-100
Operating Instructions, 02/2019, C79000-G8976-C473-03
DIN rail mounting
Removing from a DIN rail
4.2 Mounting on DIN rails
①
.
②
.
Installation
②
.
①
.
21