Night Photos Or Videos Appear Too Bright; Daytime Photos Or Videos Appear Too Bright; Photos With Streaked Subject; Red, Green Or Blue Color Cast - Letscom DL-2 User Manual

2). Night photos or videos appear too bright

<RX ZLOO JHW WKH EHVW UHVXOWV ZKHQ WKH VXEMHFW LV ZLWKLQ WKH LGHDO
flash range, no closer than 10 ft. (3 m) from the camera. Subjects
may appear too bright at closer distances.

3). Daytime photos or videos appear too bright

0DNH VXUH WKDW WKH FDPHUD LV QRW DLPHG DW WKH VXQ RU RWKHU OLJKW
sources during the day.

4). Photos with streaked subject

,Q VRPH FDVHV ZLWK ORZ OLJKWLQJ FRQGLWLRQV DQG IDVW PRYLQJ
subjects, the 8MP or 12MP or 14MP resolution settings may not
perform as well as the 3MP setting.
,I \RX KDYH PXOWLSOH LPDJHV ZKHUH IDVW PRYLQJ VXEMHFWV SURGXFH
streaks on the photo, try the 3MP setting instead.

5). Red, green or blue color cast

Under certain lighting conditions, the sensor can become
confused resulting in poor color images.
If this is seen on a consistent basis, then the sensor may need
servicing. Please contact our customer service.
6). Short video clips—not recording to the length set
Check to make sure that the Micro SD card is not full.
Make sure that the camera has good batteries in it. Near the end
of the battery life, the camera may record shorter video clips to
conserve power.

4. Camera won't retain settings.

Make sure that you have been saving the changes to any parameter
settings that you made while in SETUP mode by pressing the "OK"
key after changing the setting. If you don't save your new setting
after changing it, the camera will continue to use the original default
setting for that parameter.

5. Micro SD card is hard to install.

Please try the following step to install the memory card:
1) Insert the Micro SD card into the card slot with its label side
upwards. A "click" sound indicates that the card is installed
successfully. If the Micro SD card is not installed correctly, the
device will not display an SD card icon on the LCD in SETUP
mode.
- 18 -