Sony MZ-RH10 Hi-MD Music Transfer Version 1 for Mac (User Manual) Operating Instructions Manual page 81

Message Meaning/Remedy
GROUP FULL • You tried to create a 256th group on a disc used in Hi-MD mode or 100th
HOLD • The recorder is locked.
IN MENU • You pressed a key on the remote control while selecting a menu on the
LOW BATTERY • Batteries are weak.
MEMORY OVER • You tried to record with the recorder placed where it receives continuous
NO • You selected bookmark play without setting bookmarks.
BOOKMARKED
TRACK
NO DIGITAL • You tried to make a copy from a disc that is protected by the Serial Copy
COPY
NO DISC • You tried to play or record with no disc in the recorder.
NO DISC • You tried to erase a setting in the Disc Memory on a disc that contains no
MEMORY
NO FILE • While viewing the file list, you selected a folder that have no folders or
NO GROUP • You selected "Group Erase" with a disc without group setting.
• You tried to release a group setting with a disc that has no groups.
NO INPUT • The recorder could not detect digital input signals.
SIGNAL
NON GROUPED • You selected "Group Move" or "Group Erase", or you tried to label a
TRACK
NOT ENOUGH • You tried to edit the contents of a 1GB Hi-MD disc with insufficient
POWER TO
EDIT
NOT ENOUGH • You tried to record on a 1GB Hi-MD disc with insufficient battery power
POWER TO REC
group on a disc used in MD mode.
, You can create only up to 255 groups (on a disc used in Hi-MD mode)
or 99 groups (on a disc used in MD mode) on a disc. Keep the group
number within 255 or 99.
, Slide HOLD against the arrow to unlock the recorder (page 18).
recorder.
, Charge the rechargeable battery or replace the dry battery (page 17).
vibration.
, Put the recorder on a stable place, and start recording again.
, Set bookmarks (page 41).
Management System. You cannot make copies from a digitally connected
source which was itself recorded using digital connection.
, Use analog connection instead (page 34).
, Insert a disc.
settings in the Disc Memory (page 58).
files
, You cannot erase groups with a disc with no groups.
, Insert a disc with group settings.
, Make sure that the source is connected firmly (page 21).
group while selecting a track that does not belong to a group.
, Select a track within a group you want to edit, and then do the editing
operation again.
battery power for editing (page 75).
, Connect the AC power adaptor to the recorder or insert a fully charged
rechargeable battery or a new alkaline dry battery.
for recording (page 72).
, Connect the AC power adaptor to the recorder or insert a fully charged
rechargeable battery or a new alkaline dry battery.
81