Connecting The Recorder To Your Computer - Sony MZ-RH10 Hi-MD Music Transfer Version 1 for Mac (User Manual) Operating Instructions Manual

Connecting the
recorder to your
computer
When you connect the dedicated USB
cable directly to the USB connecting jack
on the recorder, power (bus power) is
supplied from the USB port of the
computer. This allows the recorder to be
used without power being supplied from
the battery.
Note
When using Windows ME or Windows 98SE
•
If you connect the recorder to the computer
with the disc mode on the recorder set to "Hi-
MD" (factory setting), and then insert a 60/74/
80-minute standard disc, the operation mode
of the disc may automatically change to Hi-
MD mode even if you do not record anything.
•
When you disconnect the dedicated USB
cable, the message "Unsafe Removal of
Device" appears in the computer display. This
is not a problem. Merely click "OK" to make
the message disappear.
Computer
To the USB port
Make sure to
open the cover.
Dedicated
USB cable
To the USB cable
connecting jack
1
Insert a recordable disc into the
recorder.
2
Make sure the recorder is stopped and
HOLD is released.
3
Open the cover of the
connecting jack on the recorder and
connect the dedicated USB cable to
the recorder and to the computer.
4
Check the connections.
When the connections have been
properly made, "
in the display.
When you unplug the
dedicated USB cable from the
computer or remove the disc
from the recorder
Be sure to remove the recorder or the disc
as follows. If not, damage to the data may
occur.
1
Make sure that the "REC" indication
is not displayed in the display
window of the recorder.
2
Press x on the recorder.
"EJECT DISC OK" appears in the
display.
Depending on the conditions, it may
take some time until "EJECT DISC
OK" appears in the display.
3
Unplug the dedicated USB cable
from the computer or remove the disc
from the recorder.
USB
" appears
63