Attaching The Drive Assembly For Bowl-Lift Mixers - KitchenAid 5KICA0WH Manual

USING THE ICE CREAM MAKER ATTACHMENT
Fit the freeze bowl into place over the
locating pins. Press down on the back
3
of the freeze bowl until the bowl pin
snaps into the spring latch.
Place the dasher inside the
4
freeze bowl.

ATTACHING THE DRIVE ASSEMBLY FOR BOWL-LIFT MIXERS

Be sure the Stand Mixer is OFF
1
and unplugged.
NOTE: The freeze bowl is designed to
fill all bowl-lift mixers. If the bowl pin
at the back of the bowl is too short or
too long to snap into the spring latch,
remove, and rotate the bowl so the
opposite bowl pin faces the spring
latch. Repeat step 3.
Make sure the bowl-lift handle is still
2
in the down position and the freeze
bowl and dasher are in place.
USING THE ICE CREAM MAKER ATTACHMENT | 11